Sunday, April 11, 2010

Makerbot Madness

So after two weeks of constant jamming(even after adjusting the temperature) Bre reminded me to floss Franks teeth...As you can see in the picture below, they were quite gummed up.



But we then went to Makerbot Madness at Metrix on Saturday (4/10) where everyone was more than helpful to help us diagnose our printing problem...While there we did manage to blow up another PTFE Thermal Barrier, number 3 if you've been keeping track. But luckily Matt told us to turn down our temperature and slow down our printing speed. This did wonders for us! Frank has been printing up a storm. I essentially spent the past 48 hours making parts and playing with Skeinforge settings. Check it out!

So what you're seeing here are:
1.75x Wade's Geared Extruder bodies
2.5x Coin-op bottle openers cut
3.5x Makerbot Keychains
1x Coin-op bottle opener
1x Deluxe Makerbot light

When I tried to print Wade's Geared Extruder (The guys at Metrix are using the same style on their Reprap)I just couldn't get Frank to lay down even layers. As you'll see in the following pictures, either the base/raft is warped or somewhere mid-print the layer get's shifted, mind you these prints take just over 2 hours to complete so it's always a fun surprise to come back and seethe slightly distorted mess that Frank creates. From what I hear heated build platforms help take care of the warping issues, and make the material strong so I don't have to use as complicated fill's to make the object rigid...we'll see though.

Warpage!

Warped base and crooked layers. :(

OR maybe I roll the dice on PLA

1 comment:

  1. You can remove the cap off the gear next time you have to take your extruder apart, that will stop the build up of plastic on the gear teeth.

    ReplyDelete